Audio-Technica AT4041SP
The Audio Technica AT4041SP Studio Pack offers two Audio Technica AT4041 studio
condenser microphones. Engineered to meet the most critical acoustic requirements
of professional recording, broadcast and live sound, the Audio Technica AT4041
features a smooth, extended frequency response with a slight rise in the high-frequency
region and a transformerless output for very high SPL-handling capability. The
element back plate holds a fixed charge and has been aged to provide energy
stabilization. The surface of the back plate is precision milled to ensure maximum
charge linearity, resulting in a reduction in both frequency response peaks
and diaphragm break-up distortion.
Audio-Technica AT4041SP
Features: |
Audio-Technica
AT4041SP Includes: |
- Smooth, extended frequency response with a slight
rise occurring in the high-frequency region
- Ideal for drum overheads, acoustic guitar, piano,
horns and under snare
- Low-mass diaphragm improves transient response,
increases response bandwidth and reduces handling and mechanical noise
transfer
- Transformerless circuitry virtually eliminates
low-frequency distortion and provides superior correlation of high-speed
transients
- State-of-the-art design and manufacturing techniques
ensure compliance with A-T's stringent consistency and reliability standards
- Switchable hi-pass filter and rugged turned-brass
microphone housing
|
- Two AT4041 cardioid condenser microphones
- Two AT8405a stand clamps
- Two AT8159 windscreens
- Protective wooden storage case
|
|
Audio-Technica AT4041SP
General Specifications: |
| Element: |
....... |
Fixed-charge back plate, permanently
polarized condensor |
| Polar Pattern: |
....... |
Cardioid |
| Frequency
Response: |
....... |
20Hz to 20kHz |
| Low Frequency
Roll-Off : |
....... |
80Hz, 12dB / Octave |
| Open Circuit
Sensitivity : |
....... |
-36 dB (15.8 mV), re 1V at 1 Pa |
| Impedance: |
....... |
100 Ohms |
| Maximum Input
SPL: |
....... |
145dB, 1kHz @ 1% THD |
| Dynamic Range
(Typical) : |
....... |
121dB, 1kHz @ Max SPL |
| Signal to
Noise Ratio: |
....... |
70dB, 1kHz at 1 Pa |
| Phantom Power
Requirements: |
....... |
48V DC, 3.2 mA typical |
| Switch: |
....... |
Flat, Roll-Off |
| Weight: |
....... |
4.2 Oz |
| Dimensions: |
....... |
6.28" (159.5 mm) long,
0.83" (21.0 mm) body diameter |
| Output Connector: |
....... |
Integral 3-pin XLRM-type |
| Accessories
Furnished: |
|
AT8405a stand clamp for 5/8"-27 threaded
stands; AT8159 windscreen; protective carrying case |
|
