Furman M-8L : Power Conditioner with Retractable Front Lights
FURMAN M-8L: POWER CONDITIONER with Retractable
Front Lights
The Furman M-8L Power Conditioner is the perfect low-cost AC power solution
for many rack mount systems. Install a Furman M-8L Power Conditioner in the
top slot of your rack, and the eight switched AC outlets in the rear panel will
power up and protect all your equipment up to a 15-amp load.
Furman M-Series power conditioners protect your delicate electronic equipment
by combining high voltage varistor (MOV) surge and transient suppressors. The
fast-acting supression circuit quickly responds and clamps transient voltages
to safe levels. An RFI/EMI interference filter works to prevent noise from fluorescent
lights, certain dimmers, radio transmitters, and similar sources of electronic
pollution from contaminating the AC line and from there, leaking into sensitive
audio, video, or computer circuits. The Furman M-8L is NRTL/TUV listed.
FURMAN M-8L: FEATURES |
- Standard level filtration from radio frequencies
and electromagnetic interference
- Standard level of surge suppression
- Dual pull-out rack lights with dimmer control
- 8 rear panel outlets and one front panel outlet
- Sturdy one rack space design
- 15 amp rating, with circuit breaker
- One year limited warranty
|
Circuit Breaker:
For safety, a circuit breaker is provided on the front panel. If the total
load on the Furman M-8L Power Distributor (combining all outlets) exceeds
the 15A (or 1800 watt limit), the circuit breaker will trip. If this happens,
it may be easily reset by pushing in the button. There is no need to replace
fuses.
Retractable Lamps:
The Furman M-8L power conditioner includes two pull-out
light tubes for rack illumination. For convenience in traveling, the lamps
may be pushed in, safely out of the way. When the rack is again ready
to use, they pull out easily (up to 2.75 inches, or 7 cm) and may be adjusted
to provide optimum illumination for your equipment. The units come supplied
with 5 watt night-light bulbs. Cooler-running 4 watt bulbs or even colored
Christmas tree bulbs may be substituted, if desired. Replacements are
readily available at most hardware stores or almost anywhere household
light bulbs are sold, and can be ordered from Furman. Bulbs are easily
replaced without removing the unit from the rack by unscrewing the cap
on the end of each light tube.
Switches:
The Furman M-8L power conditioner has a convenient master switch for the
rear outlets which glows when the power is on. There is a separate “Rack
Lights” switch for the lamps, plus a dimmer control knob which increases
the lamps’ brightness.
Warranty Information:
All Furman Merit Series Power Conditioners are protected by a limited
one year warranty covering manufacturer defects. |
|
FURMAN M-8L: GENERAL SPECS: |
Maximum
Output Current: |
...... |
15 Amps (1800 watts at 120 VAC) |
Line
Cord: |
...... |
6ft Captive, 14 Awg., with 3 conductor edison
plug |
| Lamps: |
...... |
2 x 5 Watts |
Operating
Voltage: |
...... |
90 to 140 VAC |
| Spike Protection: |
...... |
Line to Neutral |
| Clamping Voltage: |
...... |
188 Vpk peak @ 3,000 Amps (133 VAC RMS) |
| Maximum Surge Current |
...... |
4,500 Amps |
| Noise Attenuation: |
...... |
Transverse mode: Greater than 20 dB, 1.5 to
200 MHz |
| Dimensions: |
...... |
1.75" H x 19" W x 7.5" D |
Weight: |
...... |
5 lbs (2.3 kg) |
Construction: |
...... |
Steel Chassis, Black Painted |
Power
Consumption: |
...... |
10 watts |
| Safety Agency Listings: |
...... |
TUV, TUV-C |
Downloads
& Links: |
|
|
|
(1.59MB, pdf) |
(2.34MB, pdf)
|
|
|
